Safety Guidelines for Home Pools
Swimming pools should always be happy
places.Unfortunately, each year thousands of American families confront
swimming pool tragedies, drowning's and near-drowning's of young children.
These tragedies are preventable. These are guidelines for pool barriers that
can help prevent most submersion incidents involving young children. This
designed for use by owners, purchasers, and builders of residential pools,
spas, and hot tubs. These guidelines are not intended as the sole method to
minimize pool drowning of young children, just helpful safety tips for safer
pools.
Each year, hundreds of young children die and thousands come close to death
due to submersion in residential swimming pools. CPSC has estimated that each
year about 300 children under 5 years old drown in swimming pools. Hospital
emergency room treatment is required for more than 2,000 children under 5
years of age who were submerged in residential pools. CPSC did an extensive
study of swimming pool accidents, both fatal drowning's and near-fatal
submersions, in California, Arizona and Florida, states in which home swimming
pools are very popular and in use during much of the year.
- In California, Arizona and Florida,
drowning was the leading cause of accidental death
in and around the home for children under the
age of 5 years.
- 75 percent of the children involved in swimming pool
submersion or drowning accidents were between 1 and 3 years old.
- Boys between 1 and 3 years old were the most likely
victims of fatal drowning's and near-fatal submersions in residential
swimming pools.
- Most of the victims were being supervised by one or both
parents when the swimming pool accident occurred.
- Nearly half of the child victims were last seen in the
house before the pool accident occurred. In addition, 23 percent of the
accident victims were last seen on the porch or patio, or in the yard.
- This means that fully 69 percent of the children who
became victims in swimming pool accidents were not expected to be in or at
the pool, but were found drowned or submerged in the water.
- 65 percent of the accidents occurred in a pool owned by
the victim’s immediate family, and 33 percent of the accidents occurred
in pools owned by relatives or friends.
- Fewer than 2 percent of the pool accidents were a result
of children trespassing on property where they didn’t live or belong.
- 77 percent of the swimming pool accident victims had been
missing for five minutes or less when they were found in the pool drowned
or submerged.
The speed with which swimming pool drowning's
and submersions can occur is a special concern: by the time a child’s
absence is noted, the child may have drowned. Anyone who has cared for a
toddler knows how fast young children can move. Toddlers are inquisitive and
impulsive and lack a realistic sense of danger. These behaviors, coupled with
a child’s ability to move quickly and unpredictably make swimming pools
particularly hazardous for households with young children.
Swimming pool drowning's of young
children have another particularly insidious feature:
these are silent deaths. It is unlikely that
splashing or screaming will occur to alert a
parent or caregiver that a child is in trouble.
The best way to reduce child drowning's in
residential pools was for
pool owners to construct and maintain barriers
that would prevent young children from gaining
access to pools. However, there are no substitutes
for diligent supervision.
Why the Swimming Pool Guidelines Were
Developed
Young child can get
over a pool barrier if the barrier is too
low or if the barrier has handholds or
footholds for a child to use when climbing.
The guidelines recommend that the top of a pool barrier be at least 48
inches above grade, measured on the side of the barrier which faces away
from the swimming pool. Eliminating handholds and footholds and minimizing
the size of openings in a barrier’s construction.
For a solid barrier no indentations
or protrusions should be present, other than
normal construction tolerances and masonry
joints. For a barrier (fence) made up of horizontal and vertical members if
the distance between the tops of the
horizontal members is less than 45 inches, the
horizontal members should be on the swimming pool
side of the fence. The spacing of the
vertical members should not exceed 1-3/4
inches. This size is based on the foot width of a
young child and is intended to reduce the
potential for a child to gain a foothold. If
there are any decorative cutouts in the
fence, the space within the cutouts should not
exceed 1-3/4 inches.
The definition of pool includes spas and hot
tubs. The swimming pool barrier guidelines therefore apply to these
structures as well as to conventional swimming pools.
How to Prevent a Child from Getting
OVER a Pool Barrier
A successful pool barrier prevents a child from getting OVER,
UNDER, or THROUGH and keeps the child from
gaining access to the pool except when
supervising adults are present.
The Swimming Pool Barrier Guidelines
If the distance between the tops of
the horizontal members is more than 45 inches, the
horizontal members can be on the side of
the fence facing away from the pool. The spacing
between vertical members should not exceed
4 inches. This size is based on the head
breadth and chest depth of a young child
and is intended to prevent a child from passing
through an opening. Again, if there are any
decorative cutouts in the fence, the space
within the cutouts should not exceed 1-3/4
inches.
For a chain link fence the mesh size should not
exceed 1-1/4 inches square unless slats, fastened at the top or bottom of the
fence, are used to reduce mesh openings to no more than 1-3/4 inches.
For a fence made up of
diagonal members (latticework)
the maximum opening in the lattice should
not exceed 1-3/4 inches.
Aboveground pools should have barriers. The
pool structure itself serves as a barrier or a barrier is mounted on top of
the pool structure. Then, there are two possible ways to prevent young
children from climbing up into an aboveground pool. The steps or ladder can be
designed to be secured, locked or removed to prevent access, or the steps or
ladder can be surrounded by a barrier such as those described above. For any
pool barrier, the maximum clearance at the bottom of the barrier should not
exceed 4 inches above grade, when the measurement is done on the side of the
barrier facing away from the pool.
If an aboveground pool has a barrier on the top of the pool, the maximum
vertical clearance between the top of the pool and the bottom of the barrier
should not exceed 4 inches. Preventing a child from getting through a pool
barrier can be done by restricting the sizes of openings in a barrier and by
using self-closing and self-latching gates.
To prevent a young child
from getting through a fence or other
barrier, all openings should be small enough so
that a 4-inch diameter sphere cannot
pass through. This size is based on the
head breadth and chest depth of a young child.
Gates
There are two kinds of gates which might be
found on a residential property. Both can play a part in the design of a
swimming pool barrier.
Pedestrian Gates are the
gates people walk through. Swimming pool
barriers should be equipped with a gate or
gates which restrict access to the pool. A
locking device should be included in the
gate design. Gates should open out from
the pool and should be self closing and
self-latching. If a gate is properly designed,
even if the gate is not completely latched, a
young child pushing on the gate in order to enter
the pool area will at least close the gate
and may actually engage the latch. When the
release mechanism of the self-latching
device is less than 54 inches from the
bottom of the gate, the release mechanism for the
gate should be at least 3 inches below the
top of the gate on the side facing the pool.
Placing the release mechanism at this
height prevents a young child from reaching over
the top of a gate and releasing the
latch. Also, the gate and barrier
should have no opening greater than 1/2
inch within 18 inches of the latch release
mechanism. This prevents a young child from
reaching through the gate and releasing
the latch.
Other gates should be equipped with self-latching devices.
The self-latching devices should be installed as described for pedestrian
gates.
How to Prevent a Child from Getting
UNDER / THROUGH a Pool Barrier
In many homes, doors open directly onto the pool area or onto a patio which
leads to the pool. In such cases, the wall of the house is an important part
of the pool barrier, and passage through any doors in the house wall should be
controlled by security measures. The importance of controlling a young
child’s movement from house to pool is demonstrated by the statistics
obtained during CPSC’s study of pool incidents in California, Arizona and
Florida. Almost half (46 percent) of the children who became victims of pool
accidents were last seen in the house just before they were found in the pool.
All doors which give
access to a swimming pool should be
equipped with an audible alarm which sounds
when the door and/or screen are opened. The
alarm should sound for 30 seconds or more
within 7 seconds after the door is opened
and should be loud, at least 85 decibels,
when measured 10 feet away from the alarm
mechanism. The alarm sound should be
distinct from other sounds in the house,
such as the telephone, doorbell and smoke
alarm. The alarm should have an automatic
reset feature. Because adults will want
to pass through house doors in the pool
barrier without setting off the alarm, the alarm
should have a switch that allows
adults to temporarily deactivate the alarm
for up to 15 seconds. The deactivation
switch could be a touch pad (keypad) or a
manual switch, and should be located at least
54 inches above the threshold of the door
covered by the alarm. This height was selected
based on the reaching ability of young
children.
Power safety covers can be installed on pools
to serve as security barriers. Power safety covers should conform to the
specifications in ASTM F 1346-91. This standard specifies safety performance
requirements for pool covers to protect young children from drowning.
Self-closing doors with self-latching devices could also be used to safeguard
doors which give ready access to a swimming pool.
Indoor Pools
When a pool is located completely within a house, the
walls that surround the pool should be
equipped to serve as pool safety barriers.
Measures recommended above where a
house wall serves as part of a safety
barrier also apply for all the walls surrounding
an indoor pool.
Guidelines
An outdoor swimming pool, including an inground,
aboveground, or onground pool, hot
tub, or spa, should be provided with a barrier
which complies with the following:
1. The top of the barrier should be at least 48
inches above grade measured on the side of the barrier which faces away from
the swimming pool. The maximum vertical clearance between grade and the bottom
of the barrier should be 4 inches measured on the side of the barrier which
faces away from the swimming pool. Where the top of the pool structure is
above grade, such as an aboveground pool, the barrier may be at ground level,
such as the pool structure, or mounted on top of the pool structure. Where the
barrier is mounted on top of the pool structure, the maximum vertical
clearance between the top of the pool structure and the bottom of the barrier
should be 4 inches.
2. Openings in the barrier should not
allow passage of a 4-inch diameter sphere.
3. Solid barriers, which do not have openings,
such as a masonry or stone wall, should not contain indentations or
protrusions except for normal construction tolerances and tooled masonry
joints.
4. Where the barrier is composed of horizontal
and vertical members and the distance between
the tops of the horizontal members is less than 45 inches, the horizontal
members should be located on the swimming pool side of the fence. Spacing
between vertical members should not exceed 1-3/4 inches in width. Where
there are decorative cutouts, spacing within the cutouts should not exceed
1-3/4 inches in width.
5. Where the barrier is composed of horizontal
and vertical members and the distance between the tops of the horizontal
members is 45 inches or more, spacing between vertical members should not
exceed 4 inches. Where there are decorative cutouts, spacing within the
cutouts should not exceed 1-3/4 inches in width.
6. Maximum mesh size for chain link
fences should not exceed 1-3/4 inch square
unless the fence is provided with slats fastened
at the top or the bottom which reduce the openings
to no more than 1-3/4 inches.
7. Where the barrier is composed of diagonal
members, such as a lattice fence, the maximum opening formed by the diagonal
members should be no more than 1-3/4 inches.
8. Access gates to the pool should be
equipped to accommodate a locking device.
Pedestrian access gates should open outward, away
from the pool, and should be self-closing and have
a self latching device. Gates other than
pedestrian access gates should have a
self-latching device. Where the release mechanism
of the self-latching device is located less
than 54 inches from the bottom of the gate.
- The release mechanism should be located on the pool
side of the gate at least 3 inches below the
top of the gate.
- The gate and barrier should have no opening greater
than 1/2 inch within 18 inches of the release mechanism.
9. Where a wall of a dwelling serves as part of
the barrier, one of the following should apply:
- All doors with direct access to the pool
through that wall should be equipped with an
alarm which produces an audible warning when the
door and its screen, if present, are opened. The
alarm should sound continuously for a minimum of
30 seconds within 7 seconds after the
door is opened. The alarm should have a minimum sound
pressure rating of 85 dBA at 10 feet and the
sound of the alarm should be distinctive from
other household sounds, such as smoke alarms,
telephones, and door bells. The alarm should
automatically reset under all conditions. The
alarm should be equipped with manual means,
such as touchpads or switches, to temporarily
deactivate the alarm for a single opening of the
door from either direction. Such deactivation
should last for no more than 15 seconds. The
deactivation touch pads or switches should be
located at least 54 inches above the threshold
of the door.
- The pool should be equipped with a power safety cover
which complies with ASTM F1346-91 listed below.
- Other means of protection, such as self-closing doors
with self-latching devices, are acceptable so long as the degree of
protection afforded is not less than the protection afforded by the above.
10. Where an aboveground pool structure is used
as a barrier or where the barrier is mounted on top of the pool structure,
and the means of access is a ladder or steps, then:
- The ladder to the pool or steps
should be capable of being secured, locked
or removed to prevent access.
- The ladder or steps should be surrounded
by a barrier. When the ladder or steps
are secured, locked, or removed, any opening
created should not allow the passage of a
4-inch diameter sphere.
These guidelines are intended to provide a means of
protection against potential drowning's and narrowing to children under 5
years of age by restricting access to residential swimming pools, spas,
and hot tubs.
Exemptions
A portable spa with a safety cover which
complies with ASTM F1346-91 listed below should be exempt from the
guidelines presented in this document. Swimming pools, hot tubs, and non
portable spas with safety covers should not be exempt from the provisions of
this document.